5 Series E39 520d (M47) TOUR
32 13 060
Removing and installing power steering gear
(520d)
Caution!
If the steering gear is replaced, the front axle must be
adjusted after installation.
Make sure all parts are absolutely clean.
No dirt is allowed to enter the system.
Seal off pipe connections with plugs.
Recycling:
Observe country-specific waste-disposal regulations.
Draw hydraulic fluid out of tank and do not reuse.
Installation:
Bleed power steering.
Remove steering wheel.
Unscrew and remove splash guard.
Remove acoustic insulation on left and right.
Unscrew nut on right engine mount at bottom.
Remove bolt and separate universal joint from steering gear.
Installation:
Tightening torque 32 31 1AZ.
RA Removing and installing power steering gear (520d)
BMW AG - TIS
25.01.2013 17:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
