5 Series E39 520d (M47) TOUR
61 62 060
Removing and installing / replacing rear
window wiper motor
Remove trunk lid trim panel,
refer to 51 49 000.
Remove connector (1). Cut open cable ties (2). Unfasten screws
(3) and remove wiper motor.
Installation instructions:
Install wiper motor, but loosely tighten screws (3).
Observe tightening torque,
refer to 61 62 8AZ.
Make sure that end stop on wiper shaft bearing is correct,
refer to 61 62 090.
Turn wiper motor so that center point of drive disk is aligned with
center point of wiper axis. To do this, always use special tool
61 1 320.
RA Removing and installing / replacing rear window wiper motor
BMW AG - TIS
26.01.2013 03:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -