5 Series E39 520i (M52) SAL
Note:
Two covered (1) removal holes are located on the end face of
the radial sealing ring.
Screw special tool 23 0 490 into one of two removal holes.
Pull radial sealing ring out of transmission housing with impact
weight.
Coat sealing lips of radial seal with transmission oil.
Slide special tool 23 2 380 onto drive shaft.
Push radial seal (1) onto drive shaft up to housing. Remove
special tool 23 2 380 from drive shaft.
Drive radial seal (1) firmly home with special tool 23 2 340 .
Note:
To drive in: use plastic hammer.
RA Replacing radial sealing ring for input shaft (S5D 260Z/ 310Z)
BMW AG - TIS
30.01.2013 08:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -