5 Series E39 520i (M52) SAL
Unfasten lines on steering gear and seal bore.
Installation:
Replace sealing rings (D).
Tightening torque,
refer to Technical Data 32 41 3AZ.
Warning!
Release bolt connection of front axle support from side of car
- no personnel are permitted to stand underneath the front
axle!
Risk of injury!
Support front-axle carrier with trolley jack.
Partially loosen trim beside rear screws.
Unscrew left and right bolts.
Installation:
Tightening torque,
refer to Technical Data 31 10 1AZ.
Damaged thread,
refer to 31 00 ... Information.
Unscrew left and right nuts.
Installation:
If necessary, insert centering pin of support bearing into bore
in wheel arch.
Replace self-locking nuts.
Tightening torque,
refer to Technical Data 31 31 1AZ.
RA Removing and installing complete front axle (with spring struts) (Basis)
BMW AG - TIS
30.01.2013 09:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -