5 Series E39 520i (M52) SAL
Installation:
Pay attention to correct position of ITS head airbag in bracket
of front grab handle.
The retaining clip (2) of the front grab handle bracket (1) must be
above the ITS head airbag (3).
Important!
The retaining clip (2) must not have any sharp edges in the
area of the ITS head airbag!
Danger of damage to the ITS head airbag!
Replace bracket for front grab handle if necessary.
Unscrew bolt (1).
Push bracket on B-pillar upwards (2).
Remove bracket on B-pillar towards front (3).
Installation:
Tightening torque,
refer to Technical Data 72 12 3AZ
During installation, ensure that retaining lug is correctly seated
in body.
View of bracket on B-pillar
1.
Retaining bore for retaining lug of B-pillar bracket in body
2.
Retaining lug on bracket on B-pillar
must snap into place in retaining bore
3.
Bracket on B-pillar
4.
ITS head airbag
5.
Cover, welded seam
Unscrew bolt (1).
Replace bracket for rear grab handle (2).
Installation:
Tightening torque,
refer to Technical Data 72 12 3AZ
RA Removing and installing / replacing left or right ITS head airbag (model without
BMW AG - TIS
02.02.2013 17:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -