5 Series E39 520i (M54) SAL
Remove retaining clip with a screwdriver.
Withdraw bearing pin and remove selector arm.
Installation:
Grease bearing pin.
Grease,
refer to BMW Service Operating Fluids.
Support transmission with a workshop hoist.
Release screws (10 x).
Caution!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Install screws only in conjunction with washers.
Tightening torque, 23 00 1AZ.
Installation:
Pay attention to dowel sleeves.
If necessary, remove dowel sleeves from transmission case and
install in engine block.
Replace damaged dowel sleeves.
RA Removing and installing transmission (S5D 310Z/S5D 320Z)
BMW AG - TIS
07.02.2013 23:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -