5 Series E39 523i (M52TU) SAL
Unclip fuel lines and cable of oil level sensor out of holder (1) on
oil dipstick guide tube.
Detach oil return line (2) from oil dipstick guide tube.
Release screw (3) and remove oil dipstick guide tube.
Installation:
Replace sealing ring for oil dipstick guide tube.
Press cable duct (1) to one side and disconnect plug
connection (2) on throttle assembly.
Release screws (3) and remove throttle assembly.
Installation:
Replace sealing ring (1) between throttle assembly and
intake manifold.
Installation:
Throttle assembly plug must be locked before connection.
Hold receptacle housing and turn locking ring in direction of
arrow until lock snaps audibly into place.
Between arrow (1) and arrow (2) is an opening (3) through
which red locking pin must be visible when plug is correctly
locked.
RA Removing and installing/sealing throttle assembly (M52TU)
BMW AG - TIS
14.02.2013 12:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
