5 Series E39 523i (M52TU) SAL
Installation:
For purposes of clarity, this work step is shown on a throttle
assembly that has been removed.
Align plug so that arrow (1) is flush with arrow on bush of throttle
assembly.
Push plug onto bush. Turn locking ring in direction of arrow until
arrow (2) is flush with arrow on bush of throttle assembly.
Note:
A faulty throttle adjusts the adaptation values stored in the
DME control unit. These adaptation values must be reset after
the throttle assembly has been replaced.
Clearing adaptation values:
-
Connect DIS Tester
-
Select vehicle type
-
Select "DME Motor Electronics MS42",
carry out individual brief test
-
Continue with bottom right arrow
-
The "Fault pattern selection" window appears.
Select "Function selection" (bottom left)
-
The "Function and component selection" window
appears:
-
Select "Service functions"
-
Select "Drive"
-
Select "Digital Motor Electronics"
-
Select "Reset adaptations"
-
Select "Test schedule" (bottom left)
-
The "Test schedule" window appears.
Select "Reset adaptations"
-
Continue with bottom right arrow
For subsequent procedure, follow DIS instructions.
The new adaptation values are stored in the DME control unit after
the engine is started for the first time.
RA Removing and installing/sealing throttle assembly (M52TU)
BMW AG - TIS
14.02.2013 12:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -