5 Series E39 523i (M52TU) SAL
Lift out retainer (4).
Pull selector rod out of joint and remove washers (5).
Installation:
Grease selector rod.
Grease,
refer to BMW Service Operating Fluids.
Remove retaining clip with a screwdriver.
Withdraw bearing pin and remove selector arm.
Installation:
Grease bearing pin.
Grease,
refer to BMW Service Operating Fluids.
Support transmission with a workshop hoist.
Release screws.
Tightening torque, 23 00 1AZ.
Caution!
Do not allow the transmission to hang off from the
transmission input shaft as this will deform the clutch plate.
Pull out transmission towards rear and remove.
Installation:
Install screws only in conjunction with washers.
RA Removing and installing transmission (S5D 200G / S5D 250G)
BMW AG - TIS
14.02.2013 13:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
