5 Series E39 523i (M52TU) SAL
Installation:
Pay attention to dowel sleeves.
If necessary, withdraw damaged adapter sleeves from
transmission housing. Insert new adapter sleeves into engine
block.
Installation:
Remove release unit and release lever, clean and apply
grease to relevant points.
Installation:
Check lubrication of transmission input shaft for sticky
consistency. If grease is sticky, clutch plate must be replaced.
Check clutch plate for friction rust in taper splines and replace
if necessary.
Mechanically remove (i.e. with a cloth) old grease and lining
abrasion from taper splines of clutch plate.
Then, using a brush, apply a thin, even coat of grease over
entire area of taper splines, also in taper groove.
Grease,
refer to BMW Service Operating Fluids.
RA Removing and installing transmission (S5D 200G / S5D 250G)
BMW AG - TIS
14.02.2013 13:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -