5 Series E39 523i (M52TU) SAL
Installation:
Note dowel sleeves (1 and 2).
If necessary, remove dowel sleeves from transmission case and
mount new dowel sleeves in engine block.
Caution!
When joining up engine and transmission, ensure ease of
movement of torque converter.
Installation:
Raise automatic transmission until bore on driver is reached.
Carefully insert transmission in bore of spline with special tool
24 2 300.
Attach transmission case to engine flange.
Remove special tool 24 2 300 from lug towards front.
Installation:
The sheet metal flywheel is equipped with three recesses for the
torque converter retaining tabs.
When joining together the engine and transmission, the three
retaining tabs on the torque converter must be aligned with the
three recesses in the sheet metal flywheel.
Failure to comply with this requirement will result in damage to the
automatic transmission!
The torque converter or engine is not able to spin: this would
cause damage.
RA Removing and installing automatic transmission (A5S 325Z)
BMW AG - TIS
14.02.2013 14:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
