5 Series E39 523i (M52TU) SAL
Pull pedal assembly (approx. 3 cm) inwards until screws of master
cylinder are accessible.
Release screws.
Remove clips (1).
Detach piston rod (2) from pin.
Installation:
Grease pin.
Replace self-locking nuts. Tightening torque,
refer to Technical Data 21 52 4AZ.
Remove clutch pedal from pedal assembly.
Important!
Install clutch pedal of same design.
A = Clutch pedal with lever (1)
B = Clutch pedal without lever
Fit pedal rubber (2) on new clutch pedal.
Installation:
Check bearing bushes and replace if necessary.
Grease bearing bushes,
Grease pin.
Version with torsion spring:
Installation:
Grease inside of torsion spring coil.
Leg (1) of torsion spring must rest at rear against pedal
assembly.
RA Removing and installing/replacing clutch pedal (RHD)
BMW AG - TIS
14.02.2013 18:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -