5 Series E39 523i (M52TU) SAL
Push toggle switch for power window onto plug connector of door
wiring harness.
Open door window at front.
Loosen bolts.
Close door window down to 10 mm.
Caution!
Disconnect toggle switch for power window plug connector on
door wiring harness.
Installation:
Longitudinal setting:
Slide door window in open clamp jaws in longitudinal direction.
Height adjustment (parallelity):
Lift rear clamping jaw (door window must locate in lower jaws at
this point) and tighten down screw. Tighten front clamping jaws
(door window must abut on base of clamping jaws).
Installation:
Adjust gap dimension (A) (front edge of door window) and (B)
(top edge of door window). Measured between edge of door
window and finisher.
(A) = 5.4 mm
(B) = 10 mm
Tightening Torque,
refer to Technical Data 51 32 2AZ.
RA Adjusting left or right front door window
BMW AG - TIS
14.02.2013 20:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -