5 Series E39 523i (M52TU) TOUR
Check dowel sleeves (1) for damage and correct installation
position.
Keep sealing faces clean and free of oil. Apply a thin and even
coat of sealing compound Drei Bond 1209 (refer to BMW Parts
Service) to contact surface edges of separating face between
cylinder head and double VANOS adjustment unit.
Replace seal.
Install and secure double VANOS adjustment unit.
Attach plug connections of camshaft sensor and solenoid valves
on exhaust and inlet sides.
Important!
Left-hand threads.
Insert fitting screws for hydraulic piston on toothed shaft on inlet
and exhaust sides and tighten down.
Tightening torque 11 36 4AZ
.
RA Removing and installing or replacing double VANOS adjustment unit (M52TU / M54 /
BMW AG - TIS
16.02.2013 04:41
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 7 -
