5 Series E39 525d (M57) TOUR
Release screws.
Tightening torque, 24 00 1AZ.
Pull off transmission from engine towards rear and lower it.
Installation:
Pay attention to adapter sleeves (1 and 2).
If necessary, withdraw adapter sleeves from transmission housing
and install new adapter sleeves in engine block.
Installation:
The sheet metal flywheel is equipped with three recesses for
the torque converter retaining tabs.
When joining together the engine and transmission, the three
retaining tabs on the torque converter must be aligned with
the three recesses in the sheet metal flywheel.
Failure to comply with this requirement leads to secondary
damage on the automatic transmission.
The torque converter or engine is not able to spin: this would
cause damage.
Installation:
Bore on driver must point to center of aperture in cover plate.
RA Removing and installing automatic transmission (A5S 360R / 390R, M57)
BMW AG - TIS
18.02.2013 01:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
