5 Series E39 525d (M57) TOUR
Unfasten screws (2) and screw out axis bearing.
Installation:
Tighten screws (2).
Loosen screw (1) until limit stop can be moved.
Adjust shaft bearing to wiper motor, see below.
Observe tightening torque,
refer to 61 62 1AZ.
Axis bearing adjustment:
Remove finisher.
Installation instructions:
Push finisher with retaining clips (1) onto ribs (2).
Position special tool 61 1 320 on drive disk of wiper motor.
RA Removing and installing / replacing axis bearing for rear window wiper
BMW AG - TIS
18.02.2013 16:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
