5 Series E39 525i (M54) SAL
Release retaining screws of torque converter (3 x) with special
tool 24 1 110 .
Tightening torque, 24 40 1AZ.
Note:
Continue cranking engine at central bolt in direction of
rotation.
Only use original screws.
Protect torque converter from slipping out. To do so, insert special
tool 24 4 130 / 24 4 135 in opening in transmission housing.
Clamp torque converter.
Release screws.
Tightening torque, 24 00 1AZ.
Pull off transmission from engine towards rear and lower it.
Note:
Pay attention to adapter sleeves (1 and 2).
If necessary, withdraw adapter sleeves from transmission housing.
Insert new adapter sleeves into engine block.
RA Removing and installing automatic transmission (A5S 360R / 390R, M52TU/M54)
BMW AG - TIS
18.02.2013 01:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -