5 Series E39 525i (M54) TOUR
5.
Control lever
6.
Steering column tube
7
Wear plate
8
Spring
9
Clamping fixture
10
Mounting block
11
Rubber stop
Disconnect torsion springs (8) from both sides.
Slacken nut (1).
Remove axial grooved ball bearing (2) and clamping disc (3).
Remove retainer (4).
Press clamping fixture (9) out of adjusting lever (5) with special
tool 32 1 200 and insert 32 1 204.
Grip drive of special tool with open-end wrench.
Press clamping fixture (9) into adjusting lever (5) with special tool
32 1 200.
Adjusting lever points towards steering lock and square section on
clamping fixture must be inserted in long slot in steering column
tube.
Fit retainer (4), clamping disc (3) and axial grooved ball pivot (2).
Connect torsion spring (8) to both sides.
Caution!
Replace nut (1) and tighten to specified torque,
refer to Technical Data 32 31 3AZ.
Clamping force is adjusted via the tightening torque!
RA Dismantling and assembling complete steering column
BMW AG - TIS
19.02.2013 21:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -