5 Series E39 525i (M54) TOUR
34 00 050
Bleeding brake system with DSC3
Note:
Read and comply with General Information.
The following filling and bleeding instructions must be
observed when the following are replaced or repaired:
1.
Brake master cylinder
2.
hydraulic unit DSC3
3.
Components and connecting lines which are fitted between
these assemblies.
Caution!
All vehicles with DSC without precharging pumps must be
filled with the new DOT4 low-viscosity brake fluid!
All other models can be filled with the same brake fluid.
Connect DIS.
Call up service function "Bleeding ABS/DSC3 Hydraulics".
Connect brake fluid changer to expansion tank and switch on.
Note:
Check relevant operating instructions for each device.
Charging pressure should not exceed 2 bar.
Flushing brake system completely
Connect bleeder hose with collecting tray to bleeder valve on rear
right brake caliper.
Open bleeder valve and purge until clear, bubble-free brake fluid
emerges.
Close bleeder valve.
Follow same procedure on wheel brakes rear left, front right and
front left.
RA Bleeding brake system with DSC3
BMW AG - TIS
19.02.2013 22:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -