5 Series E39 525tds (M51) TOUR
12 61 280
Removing and installing or replacing oil
pressure switch (M51)
Switch off ignition.
Unfasten oil-filter cover to enable engine oil in filter to flow
back into the oil pan.
Installation:
Screw on oil-filter cover tightly.
Check engine oil level and top up with engine oil if necessary.
Location: On base of oil-filter.
Disconnect connector.
Unscrew and remove switch.
Tightening torque,
refer to Technical Data 12 61 1AZ
RA Removing and installing or replacing oil pressure switch (M51)
BMW AG - TIS
20.02.2013 02:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
