5 Series E39 525tds (M51) TOUR
Expose joint on front section of engine support / wheel arch with
partition wall carrier plate and front/rear section of engine support
then drill out welding spots.
Caution!
Avoid damage to adjacent sheet metal parts.
Cut off partition wall-carrier plate along seam.
Expose connections on reinforcement plate of transmission tunnel
and drill out welding spots.
Remove reinforcement plate from transmission tunnel.
Expose connection point on front / rear section of engine support
and between front section of engine support / end wall.
Drill out welding spots and open up welded seams.
RA Replacing front section of left engine support
BMW AG - TIS
20.02.2013 08:59
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -