5 Series E39 528i (M52TU) TOUR
Secure crankshaft with special tool 11 2 300 in TDC position of
1st cylinder.
Important!
Do not turn the engine back.
Remove special tool 11 2 300 before switching on the
engine.
Check camshaft setting:
Fit special tool 11 3 240 to camshafts.
Note:
The timing is correctly set if the special tool 11 3 240 rests
without a gap on the cylinder head or protrudes up to 1 mm to the
inlet side.
The timing must be reset if the special tool 11 3 240 protrudes
to the exhaust side.
If necessary, adjust camshaft timing.
Detach compressed air connection.
Remove special tool 11 3 450 .
RA Removing and installing or replacing double VANOS adjustment unit (M52TU / M54 /
BMW AG - TIS
20.02.2013 12:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -