5 Series E39 530d (M57) SAL
Caution!
Do not place crankshaft on incremental gear.
Release screws (1).
Installation:
Replace screws.
Tightening torque, 11 21 1AZ .
Remove incremental gear (2) and mount on new crankshaft.
Installation:
Coat bearing shells with oil.
Install crankshaft.
Position bearing caps 1...7 (bearing 1 on camshaft input
side) so that grooves of bearing shell guide lie on one side.
Align bearing cap precisely.
Installation:
Screws of main bearing caps must always be replaced with
new screws.
No oil is permitted in the blind bores!
(risk of cracking).
Screws washed and oiled.
Tightening specifications for main bearing:
1.
Tighten all screws on main bearing cover with jointing torque.
2.
Unfasten screws on main bearing cover 6.
3.
Strike back and front of crankshaft with plastic hammer to
center guide bearing (do not damage crankshaft).
4.
Tighten screws of main bearing cover 6 with jointing torque.
5.
Tighten down all screws of main bearing caps with special
tool 11 2 110 or with special tool
00 9 120 to torsion
angle.
RA Replacing crankshaft (M57)
BMW AG - TIS
20.02.2013 11:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -