5 Series E39 530d (M57) SAL
24 40 008
Removing and installing or replacing torque
converter (A5S 440Z)
Remove transmission,
refer to 24 00 021.
Screw special tool 24 4 000 into the torque converter.
Note:
When torque converter is removed, transmission oil flows out.
Remove torque converter.
Installation:
When installing, avoid damaging radial seal and bearing.
Slide torque converter up to first detent on transmission input
shaft.
Press torque converter into converter bell housing and rotate
until recess in torque converter hub engages in driver on
impeller and the torque converter perceptibly slides inwards.
Approx. installation depth of torque converter = 25 mm: check
with special tool 00 2 550.
Caution!
If the torque converter is not correctly installed, driver on
impeller is destroyed when transmission is connected to
engine flange.
RA Removing and installing or replacing torque converter (A5S 440Z)
BMW AG - TIS
20.02.2013 14:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
