5 Series E39 530d (M57) SAL
33 21 000
Removing and installing/replacing left or right
output shaft
On M5 models, the same repair sequence applies to removing
and installing the left and right output shafts.
Vehicles with pneumatic suspension:
Pull fuse of air supply system.
This prevents unintentional system control.
Release pipes on distributor block in order to reduce system
pressure. The vehicle stands low.
Tightening torque, 37 12 3AZ.
Release screws on left and right.
Tightening torque, 33 21 1AZ.
Installation:
Fit shims (1).
Remove and install a stub axle/wheel carrier.
Except vehicles with M54:
Remove and install pressure rod/integral link.
RA Removing and installing/replacing left or right output shaft
BMW AG - TIS
20.02.2013 15:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
