5 Series E39 530d (M57) SAL
33 21 020
Removing and installing/replacing both
output shafts
Apply handbrake.
Remove rear wheel.
Unscrew collar nut (1).
Installation:
Replace collar nut, apply a light coating of oil to contact
surface and tighten down.
Tightening torque 33 41 3AZ
.
Secure collar nut by peening on flat areas of output shaft.
Remove final drive.
Press output shaft out of drive flange.
RA Removing and installing/replacing both output shafts
BMW AG - TIS
20.02.2013 15:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
