5 Series E39 530d (M57) SAL
41 00 ...
Arranging shaped parts for cavity bulkhead
To reduce interior noise, certain areas of the body can have the cavities sealed. To do this, shaped parts are inserted
in the cavities. The shaped parts expand to fit the contact faces perfectly by heating the body to approx. 180
°
C and
holding the temperature for approx. 20 minutes.
Since it is not possible during body repairs to heat the body up and maintain it at temperature for long enough, the
following procedure has been defined for this eventuality.
This procedure is described in
Installation of shaped parts for cavity bulkhead, except cover for side member
Installation of cavity bulkhead, cover for side member.
Location of shaped parts in cavity bulkhead E39
Location of shaped parts is marked by points.
-
(1) Side of windshield,
refer to 41 21 510 Replacing front left door pillar (partial replacement) (front side panel removed)
-
(2) Reinforcement of A-pillar,
Spare part already in expanded form
-
(3) Front roof frame,
Spare part already in expanded form
-
(4) Front center roof frame,
Spare part already in expanded form
-
(5) Rear center roof frame,
RA Arranging shaped parts for cavity bulkhead
BMW AG - TIS
20.02.2013 17:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
