bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

3 RA Removing And Installing _ Replacing Navigation Computer With CD Drive > < 1 RA Notes On Handling Navigation Computers
Page 1
background image

65 90 001

Calibrating wheels for navigation system 1
(up to 9/97, measured with distance travelled)

Check tire pressure. Drive vehicle onto a flat surface, e.g. a
parking lot.

Unclip cover for towing lug. Insert special tool 00 9 280 together
with 00 9 200 in the bore.

Mark initial point on the road. Acknowledge on the on-board
monitor with START. Then drive straight ahead for 6 to 8 meters
and stop.

Acknowledge end of journey on on-board monitor.

Caution!

After stopping the vehicle, do not roll forwards or backwards.

Mark limit point and measure out distance covered. Tolerance < 1
cm. Enter the route distance reading on the on-board monitor.
Then drive at least 100 meters in a straight line. An instruction is
issued if the distance was too short or if too many steering wheel
movements were required. On public roads, comply with the
Highway Code of your country.

RA  Calibrating wheels for navigation system 1 (up to 9/97, measured with distance t

BMW AG - TIS

21.02.2013  00:06

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

3 RA Removing And Installing _ Replacing Navigation Computer With CD Drive > < 1 RA Notes On Handling Navigation Computers