5 Series E39 530d (M57) TOUR
Note:
Always replace the main bearing screws with new ones.
There must be no oil in the blind holes (risk of cracking).
Wash and oil main bearing screws.
Tightening specifications for main bearing:
1.
Tighten all screws on main bearing cover with jointing torque.
2.
Unfasten screws in main bearing cover 4.
3.
Strike back and front of crankshaft with plastic hammer to
center guide bearing (do not damage crankshaft).
4.
Tighten screw on main bearing cover 4 to jointing torque.
5.
Tighten down all screws of main bearing caps with special
tool 11 2 110 or with special tool
00 9 120 to torsion
angle.
Tightening torque, 11 11 1AZ .
Check axial play.
If necessary, check guide bearing shells, crankshaft and engine
block.
RA Replacing all main crankshaft bearing shells (M57)
BMW AG - TIS
20.02.2013 12:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -