5 Series E39 530d (M57) TOUR
Coat conrod bearing shells with oil.
Place bearing caps in position, making sure that matching
numbers are paired.
Install new connecting-rod screws.
Tighten down conrod bolts with special tool 00 9 120 or special
tool 11 2 110.
Tightening torque,
refer to Technical Data 11 24 1AZ.
Note:
Observe installation direction of reinforcement shell (1).
Arrows point forwards.
Install reinforcement shell (1).
Tighten down hexagon bolts.
Clean sealing surface.
Installation:
Replace gasket between oil intake neck (2) and oil
pump (4).
Install oil pump (4).
Tighten down screws (3).
Fit oil intake neck (2).
Tighten down screws (1).
Assemble engine.
RA Removing and installing / replacing all pistons (M57)
BMW AG - TIS
20.02.2013 12:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -