5 Series E39 530d (M57) TOUR
32 31 082
Removing and installing or replacing steering
angle sensor
Disconnect battery.
Remove lower trim from instrument panel.
Remove steering wheel.
Caution!
The steering angle sensor must be coded if it has been
replaced. A steering angle offset for Electronic Damper
Control / Dynamic Stability Control must then be carried out,
refer to BMW diagnosis program.
Remove clamping bolt.
Press down on steering spindle.
Installation:
Clamping screw lies in locating groove in upper steering spindle.
Replace self-locking nut.
Tightening torque,
refer to Technical Data 32 31 1AZ
Remove steering angle sensor (1) from steering spindle.
Installation:
Pin of pivot mounting (2) must snap into place in steering angle
sensor (1).
RA Removing and installing or replacing steering angle sensor
BMW AG - TIS
20.02.2013 16:27
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
