5 Series E39 530d (M57) TOUR
Remove clamping bolt.
Press down on steering spindle.
Installation:
Clamping screw locates in retaining groove in steering
spindle.
Replace self-locking nut.
Tightening Torque,
refer to Technical Data 32 31 1AZ.
Loosen shear-off screw with chisel or mill off screw head.
Installation:
Fit spacer tube.
Tighten shear-off screws until heads shear off.
Unfasten all lines leading to steering column from their respective
brackets.
Unscrew screw.
Unlock connector from ignition starter switch and remove.
Mechanical adjustment:
Unfasten screws (3).
Installation:
1
Bracket
2
Spacer
3
Bolt
4
Plastic guide, inside face slightly greased
5
Washer
6
Replace self-locking nut.
Tightening torque = 8 Nm
RA Removing and installing complete steering column
BMW AG - TIS
20.02.2013 16:28
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
