5 Series E39 535i (M62) SAL
Caution!
Do not damage the cylinder head.
Align camshafts with an open-end wrench so that special
tools 11 2 442 / 446 rest without a gap on the cylinder head.
Fit special tool 11 2 443 to special tool 11 2 446 / 442 and
secure with special tool 11 2 444 using the spark plug thread.
Lift timing chain and hold under tension.
Crank engine from the 45
°
before TDC position in direction of
rotation up to TDC position.
Hold crankshaft in TDC position with special tool 11 2 300.
Caution!
Remove special tool 11 2 300 before starting engine.
Caution!
Any leakage in the area of the engine breather will result in
heavy oil loss and engine damage.
Make sure that hose connection between vent pipe and
connecting piece (1) does not slip and is not leaking. Replace
sealing rings on vent pipe (1) and on angle bracket (2). Apply a
thin coat of grease to sealing rings.
Insert vent pipe (1) in angle bracket (2).
RA Removing and installing left cylinder head (M62 VANOS from 9/98)
BMW AG - TIS
20.02.2013 11:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -