5 Series E39 535i (M62) SAL
Check that dowel sleeves are undamaged and correctly located.
Fit new cylinder-head seal.
Fit cylinder head and install new cylinder head screws.
Do not wash off screw coating.
Note:
Use special tool 00 9 120 as a torsion angle bracket.
Tighten down cylinder head screws in sequence 1 ... 10.
Tightening Torque,
refer to Technical Data 11 12 8AZ.
Align camshafts with open-end wrench.
Caution!
Do not damage the cylinder head.
RA Removing and installing right cylinder head (M62 up to 9/98)
BMW AG - TIS
20.02.2013 11:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
