5 Series E39 535i (M62) SAL
Unfasten screws and lift out front seat.
Installation:
Replace screws (microencapsulation) or install old screws
with Loctite 270 (Sourcing Reference: BMW Parts Service).
Installation:
Floor carpet must not enter area between seat rails and floor
panel beside screw points (grating noises).
Installation sequence:
-
Rear seat rails flush on underside
-
Lift front seat into vehicle
-
Unlock longitudinal adjustment on lever (seat rails clip in at
back)
-
Install screws loosely in back
-
Slide front seat completely back (can also be set at an angle)
-
Align front seat
-
Install front screws loosely
Tightening sequence:
Tightening torque, refer to Technical Data 52 10 1AZ
-
Tighten down front inside and outside screws
-
Adjust front seat to front detent setting
-
Tighten down inner and outer screws at back
RA Removing and installing left or right front seat (normal / manual)
BMW AG - TIS
20.02.2013 20:43
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -