5 Series E39 540i (M62) TOUR
Replace O-ring.
Install oil guide for bow cover in the pivot rail.
Tighten down bow cover.
Install new timing chain.
Fit sprocket with chain to inlet camshaft on cylinder bank 5 to 8
with long bores aligned centrally.
Install two screws and fit flush.
Fit sprocket with chain to inlet camshaft on cylinder bank 1 to 4
with long bores aligned centrally.
Brace sprocket, press bow cover against the timing chain and
check position of long bores on both cylinder banks.
If necessary, remove sprockets once again and align long bores
centrally.
Fit sensor gear in such a way that mark on sensor gear points
upward in cylinder shaft.
Insert screws and fit flush.
RA Replacing timing chain (M62 up to 9/98)
BMW AG - TIS
20.02.2013 13:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 8 -