5 Series E39 M5 (S62) SAL
Installation
Installation of cylinder head is described separately from removal.
Clean sealing faces of cylinder head and engine block, if
necessary, remove gasket debris using a wooden scraper. Make
sure no gasket debris drops into the oil and coolant ducts.
Threaded bores in engine block must be free of dirt and oil (risk of
cracking).
Coat joint between engine block and timing case cover with
Drei Bond 1209 (refer to BMW Parts Service).
Check dowel sleeves for damage and correct installation position.
Install new cylinder head seal.
Put the cylinder head on. Install new cylinder head bolts. Do not
wash off screw coating.
Note:
To tighten down cylinder head bolts: Use special tool 11 2 250 .
At narrow points, use a socket with 3/8" drive and a short
extension.
Use special tool 00 9 120 as a torsion angle bracket.
RA Removing and installing left cylinder head (S62)
BMW AG - TIS
21.02.2013 06:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
