5 Series E39 M5 (S62) SAL
Cylinder bank 1 to 4:
Check camshaft adjustment.
Note:
Groove on 1st bearing cap is a little wider than groove in
camshaft.
Groove of inlet and exhaust camshafts must be inside groove on
1st bearing cap.
Cylinder bank 5 to 8:
Check camshaft adjustment.
Note:
Groove on 1st bearing cap is a little wider than groove in
camshaft.
Groove of inlet and exhaust camshafts must be inside groove on
1st bearing cap.
If necessary, adjust camshaft timing.
Cylinder bank 5 to 8:
Replace sealing rings.
Fit oil line to VANOS adjustment unit.
Tightening torque, refer to 11 36 9AZ .
Cylinder bank 1 to 4:
Remove special tool 11 7 130 from VANOS adjustment unit.
Replace sealing rings.
Attach oil line to VANOS adjustment unit.
Tightening torque, refer to 11 36 9AZ .
Assemble engine.
RA Removing and installing left cylinder head (S62)
BMW AG - TIS
21.02.2013 06:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 22 -
