5 Series E39 M5 (S62) SAL
Cylinder bank 5 to 8 (inlet side):
Version up to 9/2001
Caution!
Observe installation direction of plate spring (2).
Note:
The small support diameter of the plate spring (2) points in the
direction of the supporting ring (3). Supporting ring is supported
with retaining lugs in spline hub (1).
Insert plate spring (2) and supporting ring (3) in spline hub (1).
Cylinder bank 5 to 8 (inlet side):
Version from 9/2001
Caution!
Observe installation direction of plate spring (4).
The small support diameter of the plate spring (4) points in the
direction of the spline hub (1). Supporting ring is supported with
retaining lugs in spline hub (1).
Insert plate spring (4) and supporting ring (5) in spline hub (1).
Cylinder bank 5 to 8 (inlet side):
Install spline hub (1) with plate spring and supporting ring.
Note:
Align spline hub (1) so that oil pump is positioned as shown in
picture.
Cylinder bank 5 to 8 (inlet side):
Fit spacer ring (2).
Insert all bolts and initially tighten without play.
Then slacken bolts again until spline hub (1) can be moved with
fingers.
RA Removing and installing both cylinder heads (S62)
BMW AG - TIS
21.02.2013 06:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 19 -
