5 Series E39 M5 (S62) SAL
Cylinder bank 5 to 8:
Caution!
Make sure both VANOS splined shafts remain in initial
position during installation.
Rotate splined shafts of inlet and exhaust sides until spur toothing
is engaged.
Push VANOS adjustment unit with splined shaft into VANOS gear
until helical cut splines (2) are positioned shortly before meshing
with spline hub (1).
Cylinder bank 5 to 8 (exhaust side):
If the helical cut splines cannot be pushed into the spline hub (1):
Place special tool 11 7 150 on bore in spline hub (1). Rotate
spline hub (1) against direction of rotation until splined shaft (2)
is positioned with spline hub (1) exactly "tooth-to-tooth gap".
Caution!
The "first" matching tooth must engage.
Cylinder bank 5 to 8 (inlet side):
Place special tool 11 7 150 on bore in spline hub (1). Rotate
spline hub (1) against direction of rotation until splined shaft (2)
is positioned with spline hub (1) exactly "tooth-to-tooth gap".
Caution!
The "first" matching tooth must engage.
Cylinder bank 5 to 8 (inlet side):
Align radial piston pump to driver on spline hub.
Note:
Picture shows a schematic representation.
RA Removing and installing both cylinder heads (S62)
BMW AG - TIS
21.02.2013 06:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 26 -
