5 Series E39 M5 (S62) SAL
Note:
The end cover is in the set with the radial sealing ring.
If necessary, lift out the radial seal and drive in new sealing
ring using special tool 11 1 230 in conjunction with special
tool 00 5 500.
Check for correct fit of hollow bushes.
Replace seal.
Coat contact points on joint along oil sump with Drei Bond 1209
(refer to BMW Parts Service).
Fit special tool 11 2 390 on crankshaft.
Coat sealing lip of radial sealing ring with oil.
Slide on end cover.
Carefully remove special tool 11 2 390.
Replace the sealing washers under the screws (1).
Insert all screws and tighten down end cover.
RA Replacing crankshaft radial seal (M62/S62)
BMW AG - TIS
21.02.2013 07:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
