5 Series E39 M5 (S62) SAL
Caution!
The camshafts remain locked in position with special tool
11 7 120 .
Carefully rotate engine at central screw against direction of
rotation until there is noticeable resistance and spline hubs
are at the stop.
Note:
This procedure creates compensation for play. Only with this
compensation for play is the timing diagram correctly set.
Then crank engine again in direction of rotation until 1st cylinder is
at TDC firing position.
Secure vibration damper in position with special tool 11 2 300 .
Cylinder bank 5 to 8:
Note:
To tighten down screws on VANOS gear: Use special tool
11 7 200 .
Tighten down six accessible bolts (three on exhaust side and
three on inlet side) on VANOS gear to 10 Nm.
Cylinder bank 1 to 4:
Note:
To tighten down screws on VANOS gear: Use special tool
11 7 200 .
Tighten down six accessible bolts (three on exhaust side and
three on inlet side) on VANOS gear to 10 Nm.
RA Removing and installing/replacing toothed shafts of VANOS gear on left and right
BMW AG - TIS
21.02.2013 15:14
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 18 -
