5 Series E39 M5 (S62) SAL
12 14 523
Replacing pulse generator for inlet camshaft
(S62)
Interrogate fault memory of DME control unit.
Switch off ignition.
The instructions apply to removing and installing both pulse
generators for the left and right inlet camshafts.
Illustrations show removal of the left pulse generator for inlet
camshaft.
Installation location is at rear of cylinder head.
E39 only:
Release retaining clips (1).
Caution!
The air duct can brake at the firewall if not carefully removed
and installed.
Carefully twist air duct (2) upwards until it is no longer locked in
firewall. Pull air duct (2) forwards and remove towards top.
E52 only:
To remove left pulse generator for inlet camshaft:
Remove left partition wall for equipment compartment.
To remove right pulse generator for inlet camshaft:
Remove right partition wall for equipment compartment.
RA Replacing pulse generator for inlet camshaft (S62)
BMW AG - TIS
21.02.2013 19:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
