5 Series E39 M5 (S62) SAL
Cylinder bank 1 to 4 (exhaust side):
Version up to 9/2001
Caution!
Observe installation direction of plate spring (2).
Note:
The small support diameter of the plate spring (2) points in the
direction of the supporting ring (3). Supporting ring is supported
with retaining lugs in spline hub (1).
Insert plate spring (2) and supporting ring (3) in spline hub (1).
Cylinder bank 1 to 4 (exhaust side):
Version from 9/2001
Caution!
Observe installation direction of plate spring (4).
The small support diameter of the plate spring (4) points in the
direction of the spline hub (1). Supporting ring is supported with
retaining lugs in spline hub (1).
Insert plate spring (4) and supporting ring (5) in spline hub (1).
Cylinder bank 1 to 4 (exhaust side):
Note:
Fit spline hub (1) with plate spring and supporting ring so that
bore hole (2) is positioned as shown in illustration.
Cylinder bank 1 to 4 (exhaust side):
Fit spacer ring (2).
Insert all bolts and initially tighten without play.
Then slacken bolts again until spline hub (1) can be moved with
fingers.
RA Replacing right camshafts (S62)
BMW AG - TIS
21.02.2013 07:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 16 -
