5 Series E39 M5 (S62) SAL
12 72 010
Removing and installing/replacing throttle
actuator (S62)
Switch off ignition.
Remove and install intake air manifold,
refer to 11 61 050.
Disconnect plug connections (1).
Unclip cables (2) from cable guides.
Disconnect plug connections (1) on left knock sensor pair.
Disconnect plug connection (1) on throttle actuator.
Unhook cable duct (2) from mounts and raise approx. 2 cm.
Installation:
Check seating of rubber grommet on ignition coil cable.
Unclip cable strip (3) from injector valves, push upwards and tie
back with cable ties (e.g. to engine hood).
RA Removing and installing/replacing throttle actuator (S62)
BMW AG - TIS
21.02.2013 16:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
