5 Series E39 M5 (S62) SAL
When the main flow oil filter cap is opened, engine oil flows from
the oil filter housing back into the oil sump.
Open main flow oil filter cover and remove.
Installation:
Tightening torque, 11 42 2AZ.
Installation:
Replace O-ring (2) and coat with oil.
Note:
A small amount of engine oil emerges when the oil pressure
switch is removed. Have a cleaning cloth ready.
Disconnect plug connection (1).
Unscrew switch.
Tightening torque, 12 61 1AZ.
Note:
Assemble car and set in horizontal position.
Start engine and run at idle until oil indicator lamp goes out.
Switch off engine and wait approx. 5 minutes.
Then check engine oil level.
Top up engine oil if necessary.
RA Removing and installing/replacing oil pressure switch (S62)
BMW AG - TIS
21.02.2013 16:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
