5 Series E39 M5 (S62) SAL
Warning!
When tensioned, the spring coils must rest completely in the
spring holder recess.
Special tool 31 3 3411 must not be tensioned or unfastened
with an impact screwdriver.
Clamp the coil springs together, but only until load is relieved
on the thrust bearing.
The coils may not be tensioned on a block.
Only untighten the nut if both spring coils are completely
inserted in the spring holder recess! If necessary, repeat the
process.
Brace with open ring spanner and unfasten nut with special
tool 31 2 210 or with open-end socket tool (width across flats
24).
Remove spring strut.
Important!
Screw connection of support bearing to piston rod must not
be released with impact screwdriver!
If a new coil spring is installed, observe Notes 1 ... 3!
Note 1:
Relieve tension on special tool 31 3 341 and remove coil spring.
The special tool must not be tightened or untightened with an
impact screwdriver.
Note 2:
Mount new coil spring in special tool 31 3 341 with larger spring
diameter at bottom.
RA Replacing front left or right spring strut shock absorber (high)
BMW AG - TIS
21.02.2013 21:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
