5 Series E39 M5 (S62) SAL
Unfasten disk collar nut (1).
Unscrew and remove eccentric screw.
Installation:
Replace disk collar nut.
Fit eccentric washer (2).
Tightening Torque,
refer to Technical Data 33 32 20AZ.
Unfasten screw and remove.
Installation:
Insert locking nut (1) in recess on rear axle carrier and tighten
down screw.
Tightening Torque,
refer to Technical Data 33 32 20AZ.
Support wheel carrier with workshop hoist.
Unfasten nut, unfasten screw and remove swinging arm.
Installation:
Replace nut. Tightening Torque,
refer to Technical Data 33 32 22AZ.
Not M5:
Check chip resistance protection for damage, replace if
necessary.
Remove chip resistance protection, if necessary unfasten screw.
RA Removing and installing or replacing left or right swinging arm
BMW AG - TIS
21.02.2013 22:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -