5 Series E39 M5 (S62) SAL
Unfasten brake lines.
Important!
Do not mix up brake pipes (mark if necessary).
Installation:
Pipe connections
(F) from THZ circuit V to hydraulic control unit circuit V (front-
axle circuit)
(R) from THZ circuit H to hydraulic control unit circuit H (rear-
axle circuit)
(FR) from hydraulic control unit FR to front right wheel brake
(FL) from hydraulic control unit FL to front left wheel brake
(RR)from hydraulic control unit RR to rear right wheel brake
(RL) from hydraulic control unit RL to rear left wheel brake
1
Diaphragm flow damper
Tightening torque, refer to Technical Data 34 32 1AZ
Note:
Note installation position of diaphragm flow damper. The pin
must engage in the bore.
Installation:
Note tightening torque,
refer to 34 50 3AZ
.
Unfasten screw and remove hydraulic control unit.
RA Removing and installing/replacing hydraulic unit ABS/ASC+T, DSC3 up to 09/98
BMW AG - TIS
21.02.2013 23:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
