5 Series E60 520d (M47T2) SAL
Installation:
Clean gasket residue from sealing surfaces.
At transition to half-moon sections on inlet and exhaust sides,
apply a thin and uniform sealing bead of Drei Bond 1209, refer
to BMW Parts Service, approx. 2 mm high and 2 mm wide.
Installation:
Replace cylinder head cover gasket.
When fitting cylinder head cover, ensure seal is correctly seated
on rear side of cylinder head.
Installation:
Screw in all retaining elements of cylinder head cover and initially
tighten without preload.
Tighten down retaining elements of cylinder head cover in
sequence 1 ... 22.
Tightening torque, 11 12 11AZ .
RA Removing and installing/sealing cylinder head cover (M47TU / M47T2)
BMW AG - TIS
22.01.2013 20:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -